Innovative products – cost-efficient, economical with materials and with a low carbon footprint? Pioneering lightweight construction processes have great potential.
Reducing part weight while maintaining or improving mechanical properties is your ambitious goal. And fibre-reinforced or foamed parts are two possible solutions.
How to make significant cost savings? Through optimised part design, reduced weight and the combination of different lightweight construction processes and materials.
ARBURG is your partner. And active in networks that develop and optimise processes and materials. In addition to the technology, we also offer comprehensive technical advice.
Benefits of the FDC process
Combining carbon or glass fibre rovings and plastics such as PP, PA, PET and PC/ABSs is up to 40% cheaper than special glass fibre-reinforced PBT, for example.
The FDC process is fully integrated in the control system and dedicated symbols enable the process to be programmed easily and flexibly.
A special screw geometry enables gentle preparation of the melt and a high proportion of long fibres in the part. With an additional thermoplastic cylinder module, the ALLROUNDER can also be used for conventional injection moulding.
Continuous fibre strands are cut to the desired size via the lateral feeder and fed directly into the liquid melt. Mechanical part properties can be selectively influenced.
Fibre direct compounding
With the FDC process, you are free to choose the fibre length and proportion, meaning that you can selectively influence the part properties. The benefits for you? You can substitute more expensive materials and produce lightweight yet resilient parts.
Combining MuCell® and chemical foams creates cups that are very light, have excellent insulation properties, and can be easily recycled after multiple use.
Cable drive housings made from PP with 30% long glass fibres (incinerated on the left) produced in the FDC process have a resilience similar to that of parts made from PBT and are also 30% lighter.
If gas or water is introduced into the mould cavity using fluid injection technology (FIT), cavities can be created in the part. This significantly reduces materials and cycle time.
Automated production cells from a single source
Want to increase added value, optimise the injection moulding process, automate further, and integrate innovatively? Then we are your partner as a primary contractor. As we already are for many leading companies worldwide.
Want to know more? You can find more information on the topic here.
This might also be of interest
Whether in injection moulding or additive manufacturing: with our machines, you can process all commercially available plastic granules and original materials.
Take advantage of our expertise – from moulded part design to mould and machine configuration. And application technology, for example in our Customer Center.
From practical experience – for practical use. That's how we share knowledge. You benefit from our know-how. Targeted, fast, and cooperative. With our machines, for your purposes.