Course objective: Independent work with the ARBURG MULTILIFT V and MULTILIFT SELECT robotic systems on the ALLROUNDERs

Target group: Installation technicians, machine operators, mould makers and designers

Preqiusites: Participation in a SELOGICA optimization course

Course duration: 3 days, Course fee: 520,- EUR

Documents: Course folder with accompanying texts and CD

Course objective: Programming of a six-axis robot system

Target group: Machine setters, operators

Preqiusites: Completion of previous robot system course.

Good programming skills on MULTILIFT V

Course duration: 5 days

Course fee: 1200,- EUR

Documents: Course folder with accompanying texts and CD

Introduction to and operation of the ARBURG MULTILIFT V (vertical (V) mould entry from above) robotic system on the ALLROUNDERs

Various practical applications of part removal with suction device or gripper via the MULTILIFT V

Integrated production control with subsequent palletising or subsequent selection

Practical exercises with various set-down versions

Servicing, additional accessory equipment

Introduction of the six-axis robot system

Technical data

KCP- operating panel

Operating modes

Safety circuits

Movements of the six-axis robot system

Defining new teach-in points

Programming of home position sequence

Programming of production sequence

Programming of various part removal, set-down and patterned set-down sequences

Monitoring functions

Operating zone monitoring